Re: Samsung PN64H5000 flickering magenta problem
Sorry to highjack thread, but do you turn VS voltage up or down.
I have a Samsung Ps51d8000 with the same problem but with a
blueish spodge in th center plus alot of screen burn
Thanks
Alan....
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Lj41-04516a
Ok, I will go further afield (World) can anyone Identify the diode in question or does anyone have a scrap board that I can buy off them.
Thanks
Alan.
Leave a comment:
-
Lj41-04516a
Hi,
All does anyone in the UK, have a scrap board of the above, it is from a Samsung PS50Q7HDX.
What I need is diode 5904 from the sub-board LJ92-01216B, I have looked for
a circuit diagram but cannot find one down to component level for that board,
I managed to source a complete one from the USA, and it works fine. There is a ticking sound coming from the sub-board, and after doing a side by side measure of components the above diode is O/C
If anyone has one, I would be grateful or can tell what the diode is I need, so I can get this...
-
-
Vestal backlight strip 7020pkg 72ea
Hi
Has anyone got the above backlight strip that is for parts or failed,
I am after the socket for them as the one on the board I am trying to
repair has suffered irreparable damage.
Thanks
Alan.
-
Re: Vestel 50 led
Hi
Are they the same (the flimsy wiring socket has fallen off)
I got one for the 2D version and on the original all LED'S
have polarity the same way but the replacement has 36 one way
and the others reversed.
Can you by any chance show a picture of the LED backlight connector
for a VES500UNVA to see if they are wired the same way from the power supply.
Thanks
Alan....
Leave a comment:
-
Re: finlux 50fme242b-t flashing backlight leds
In the picture P#27 shows one of the area's where these have come from I
am not sure what they are as it does not appear to be a circuit.
There are five of these along the length of the backlight.
The dimmer ones run the whole length of the strip.
Leave a comment:
-
Re: finlux 50fme242b-t flashing backlight leds
Hi All
Can someone advise me if the above backlights are repairable
and what does it entail, there is one led out in the strip but
there are 22 pairs that are reduced in brightness out of 72.
There also seems what look like resistors blown off the board
but not sure on that, any help would be greatly appreciated.
[ATTACH]180686[/ATTACH]
AlanRe: finlux 50fme242b-t flashing backlight leds
Hi All
Can someone advise me if the above backlights are repairable...
Leave a comment:
-
Re: finlux 50fme242b-t flashing backlight leds
Sorry cannot get link to work will have to copy and paste
FINLUX-50FLHKR242BHC-VES500UNVA-50INCH-7020PKG-72EA-DRIVE-CHIP-10-PIECE-KITLast edited by crt man; 07-23-2018, 04:59 AM.
Leave a comment:
-
Re: finlux 50fme242b-t flashing backlight leds
Hi All
I know this is an old thread, but I have been asked by a work
colleague to have a look at the above-mentioned set.
I know it's a backlight issue but the screen is a Vestal VES500UNVL
I have seen on E-bay these [URL="https://www.ebay.co.uk/itm/FINLUX-50FLHKR242BHC-VES500U"] for a Vestal VES500UNVA.
Are these likely to work or are they completely different for
this set and what are the pitfalls with doing one of these thanks
Alan.Re: finlux 50fme242b-t flashingLast edited by crt man; 07-23-2018, 04:42 AM.
Leave a comment:
-
Re: Post The Led Backlights Your Fixing Here.
I have done two of them, and don't know about
anyone else, but have found back light setting up full tilt
Alan....
Leave a comment:
-
Re: Panasonic TX-40AX630B flashing green standby
Hi
If you take the panel apart the strips have a part number on them,
with a bit of luck and a search you may find one.there could be two different
strips in there.
If not you need a strip from the same maker as it needs same voltage /
current specs.
Alan....
Leave a comment:
-
Re: Led Backlight Stacking Repair Video
Looked at settings again, seen backlight
was set at 97 after I said to keep it down.
They must have thought not given remote
I could not find out the level.
Will tell them again but if the backlights go again
I shall not be repairing it.
Alan.
Leave a comment:
No activity results to display
Show More
Leave a comment: