Re: Beko 30inch blank screen after 2 sec.
Also, all the test point voltages on the connector, were the same voltage,
except for the 24v line, was at 24.2v, not the 23.7v with the CCFL's illuminated.
Cheers
HK-Steve
New Member
Last Activity: 03-25-2013, 02:21 AM
Joined: 03-22-2013
Location: Wadenswil
-
Re: Beko 30inch blank screen after 2 sec.
No, the backlight did NOT come back ON.
Will post a pic tomorrow, as it is night time here.
Not sure what it will show you, but any help would be great.
CheersLeave a comment:
-
Re: Beko 30inch blank screen after 2 sec.
I do not think so, as the corner was lifted about 2mm, not near the connectors for the CCFL's.Leave a comment:
-
Re: Beko 30inch blank screen after 2 sec.
Thankyou everyone,
I have worked out it is the inverter board, I move it up just a little on one corner, and out goes the backlight.
I have soldered as many points as I can, but have no way to reflow the board myself.
Does someone have the equipment, and time??
Or a board they are willing to sell??
Much Appreciated.
Cheers
SteveLeave a comment:
-
Re: Beko 30inch blank screen after 2 sec.
Thanks Guy's,
Appreciate all the suggestions.
First, I will reflow the solder for the connections, They all looks good, but no harm to try.
I have no spare CCFL's to plug in, but as it started to work for 30 mins, that would suggest the CCFL's are ok, yes??
Also, I am sure I saw somewhere here, about a service menu, but can not find the thread now.
Love this forum already, great stuff everyone.
CheersLeave a comment:
-
Re: Beko 30inch blank screen after 2 sec.
I was about to check the voltages,
Pulled the Inverter board out, as I wanted to know the pinout for the voltages, took a picture,
Then put the Inverter board back in, (this is the 3rd time out and back in)
Fired up the TV, and it works!!!!!!!
Cycled the TV ON/OFF 5 times, it runs,
I will run it tonight and tomorrow, seems a bit strange.
As for the running voltages, the 24v line is 23.7volts
Vsel = 4.1
VEPWM = 5.0
VIPWM = 0.0
On/Off = 5.0
...Leave a comment:
-
Beko 30inch blank screen after 2 sec.
Hello Everyone,
I have spent some time today trying to get a Beko 30inch LCD tv working.
I do not have a specific model number, as it has it's case removed.
On the Firmware Chip was - LT30FLF ver 2.9 2005
Screen goes blank after 2 seconds, sound is good.
The Inverter board is a Model V144-001.
Main Board is Model V2327B/D 111-A48F.
The LCD panel is V296W1-L11.
I went through the Great post on troubleshooting, this is what I found,
1- Bad capacitors,
I replaced them all on the Inverter board,...
No activity results to display
Leave a comment: