Re: Vizio e321vl u18 chip pinouts
It looks good so far I thinks its a permanent fix. I am thankful for your help tom....
iph0nespark
Member
Last Activity: 02-10-2013, 09:18 PM
Joined: 01-26-2013
Location: Ishpeming
-
Re: Vizio e321vl u18 chip pinouts
I do believe so its been on ever since. Ive been shutting it off and on every half an hour to be sure, Thanks for your help I appreciate it....Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
It works but ill update in a little while after testingLeave a comment:
-
Re: Vizio e321vl u18 chip pinouts
Thanks ill try it nowLeave a comment:
-
Re: Vizio e321vl u18 chip pinouts
It is it completely came offLeave a comment:
-
Re: Vizio e321vl u18 chip pinouts
So it should work fine with pin 3 and 4 connected?...Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
I mean 8 and 7Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
Also there on the opposite site of the one circled when you look at the picture the first 2 pins on the left are bridged somewhere but not by the pads i checked are they suppose to be?Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
How do I know the pin number? What number is the one I have circled?Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
Why would I need to? And this will make.it work right...Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
I believe this is it MX25L6406E. I would greatly appreciate it if someone could use an ohm meter and find where that trace leads to so I can solder a jumper to itLeave a comment:
-
Re: Vizio e321vl u18 chip pinouts
yes i did but i ran a jumper to that one. I just need to figure out which one do i put to that circled pin...Leave a comment:
-
Re: Vizio e321vl u18 chip pinouts
I saw the 3 spots where it could have been connected to but i didnt know which one...Leave a comment:
-
Vizio e321vl u18 chip pinouts
Hey guys I went on my own replacing the epprom however when I was soldering the epprom one of the connections came off and I was wondering If I could run a jumper to it. When looking at the board it's third pin going from left to right on the side of the chip with the recessed dot. Please help me so I can get it working. Btw I know I need the epprom because I tested it before soldering and it worked and when I went to solder it the connection came off
No activity results to display
Leave a comment: