Yesterday I had a little time left and I was able to test:
Stby 3.3V was 3.48V, can I continue with the bridge to Power On because I read somewhere that there is an allowable percentage of deviation. Is this normal?
The CN6102 is missing +12V.
Venci
New Member
Last Activity: 11-27-2025, 04:22 AM
Joined: 11-16-2025
Location: Eschborn/ Hessen
-
So, both boards I have do nothing. Nothing lights up, no LED for readiness to turn on.
Board 1 - Nothing lights up and when I unplug it from the outlet it gives off a jolt of electricity (the first time I found it by touch and it was not very pleasant).
Board 2 - also without any indications of operation.
On both I measured the voltage to Q6102 -AC 80V relative to the ground of the Primary board.Leave a comment:
-
Sony KDL 55EX725 current from the plug
Hello, thanks for accepting me into the group. I'm not a professional, this is just a hobby.
Now I have two G6 boards, both without any signs of working. When I unplug one of them, it gives off a current from the plug - 80-90 volts. From which point do you think I should start looking for the problem. The fuses are healthy.
I apologize if my English is not good, but I use a translator
Thank you in advanced -
Hello, thanks for accepting me into the group. I'm not a professional, this is just a hobby, but the topic was quite useful for me to deal with a G6 that was flashing 2 times.
In order not to open a new topic, I decided to ask here.
Now I have two G6 boards, both without any signs of working. When I unplug one of them, it gives off a current from the plug - 80-90 volts. From which point do you think I should start looking for the problem. The fuses are healthy.
I apologize if my English is not good, but I use a translator
Thank you in advancedLeave a comment:
No activity results to display
Leave a comment: