blownelco
Member
Last Activity: 01-28-2025, 01:34 PM
Joined: 04-13-2008
Location:
-
i found it -
hp 15S-fq2051nb boardview request
Hello Everybody,
I'm looking for a board view and schematics for a water damaged mainboard.
mainboard: da0p5mb38A0 REVA
model OP5H
cpu intel 11 gen
thanks -
hello, i also need boardview for probook 430 g5, board X8B DA0X8BMB6F0
for repair power buttonLeave a comment:
-
Re: Pareb mb 8l rev.2.0
ok got it open with another version of allegro pcb designer ( vers 16.6).
but still need the schematics!Leave a comment:
-
Re: Pareb mb 8l rev.2.0
Thanks for the boardview but it is password protected, i still need the schematics tooLeave a comment:
-
schematic acer Travelmate P2510 needed
Please I need Schematics for Acer TravelMate P2510-G2-M TMP2510-M-394D
Motherboard: PAREB MB 8L REV: 2.0Leave a comment:
-
Re: Toshiba SATELLITE C50-A-19U
Hello,
PSCG6E 1.4 4MB.bin.zip (2.01 MB, 61 views)
from
SMDFlea did the trick for me
thanksLeave a comment:
-
Re: Acer tmp259-g2-m
hello, thanks for helping me out, i just programmed the old bios file in new chip and it works againLeave a comment:
-
Acer tmp259-g2-m
Hello,
I need bios bin file for this laptop.
the chip is GD25B127D ( 16MB)
mainboard Quanta ZAA X32 ( ZAAA)
cpu i5-7200U
can anyone help me? -
Re: Packard Bell LJ67 Compal LA-5021P no display
hello,
thanks for that info, i fixed it without removing the chip.
usb stick with KAYF0X64.FD
powered up with fn + esc
lights flashing for while.
repowered board and it starts again.
i hope it will stay ok.
greetingsLeave a comment:
-
Re: Packard Bell LJ67 Compal LA-5021P no display
Hello,
I think i have a laptop with the same problem.
Where is the bios onto that board is it U60 P3017THF ?
What kind of programmer do i need for that bios?
thanks in advanceLeave a comment:
-
Panasonic TH-42PX80EA standby PS
Hello,
I have a Panasonic with dead standby powersupply.
The buffer elco C407 was bulged and the fuse F403 was blown.
I replaced the fuse and capacitor. As capacitor i took a 33ùF instead of the 22ùF. Is this a problem?
At power up the fuse was gone again and IC409 MIP3E30 blownup.
I have bought a new one and installed.
After connecting power (without powerswitch on) i have now about 235VDC
Isn't that to low, i was expecting +/- 300V?
(230V AC grid)
Someone an idea what is wrong?
...
No activity results to display
Leave a comment: