Hello all, I have a 26" lcd that will not power up (no green led or otherwise). I have read the two other threads regarding this model and have replaced most of the caps on the power supply. For the lead going to the scaler board, I am getting +24v at pin 3, +17v at pin 1 (should be +16v +/- 1V), with ground at pin 6 (all this per service manual for said unit). None of the caps had any signs of obvious damage but I hoped that was the problem. I don't think I am getting power to the lead going to the on/off switch. When I tested the led with my meter it lit up green. I have run out of ideas...

Hello all, I have a 26" lcd that will not power up (no green led or otherwise). I have read the two other threads regarding this model and have replaced most of the caps on the power supply. For the lead going to the scaler board, I am getting +24v at pin 3, +17v at pin 1 (should be +16v +/- 1V), with ground at pin 6 (all this per service manual for said unit). None of the caps had any signs of obvious damage but I hoped that was the problem. I don't think I am getting power to the lead going to the on/off switch. When I tested the led with my meter it lit up green. I have run out of ideas...