Re: Westinghouse L2410NM 24" LCD power goes on and off, blue light flickers



Yes I did cut the leads already, unfortunately I don't remember which cap it was. I know it was either one of these two, that are marked by red boxes in the picture. I tested F100, F102, F104, F105 and they all tested 0.0 Ohms, I didn't see an F101 or F103....

Re: Westinghouse L2410NM 24" LCD power goes on and off, blue light flickers



Thanks for bearing with me. Here are more pics of the mainboard, New power supply and Invertor Board.

I definitely would like to test the old power supply as well, I just don't know where to place the multimeter probes on the board to test for output voltage....

Re: Westinghouse L2410NM 24" LCD power goes on and off, blue light flickers



LOL, sorry I guess my post was a little scattered, it was pretty late when I posted last night. The first thing I'd like to find out are what leads I need to test for output voltage on the new power supply. It should be fine, as It was purchased as "new" from a fairly mainstream online electronics parts supplier, but I would've expected the power led to at least light up on the front of the monitor. I guess right now I'd just like to verify that the mainboard and invertor are...

Re: Westinghouse L2410NM 24" LCD power goes on and off, blue light flickers

Hi all, firstly I'd like to thank all those who contributed to this thread since it's inception. I was able to bring my L2410NM back to life a couple of years ago because of this thread, unfortunately like a couple others on here I just replaced the bad ones on the power supply the first time and not all the caps as I should have.

This is gonna be long so please bare with me. For about the past 6 months I'd get intermittent blank screens while using the monitor, it didn't happen very often...