Re: Please I need bios for Asus FX705G



worked for me. thanks...

Re: Dead hp dv6 (quanta ut3)



Replaced. No luck. Quitted from this motherboard. I don't know if this is relevant to somebody who still trying to find out the issue but when I replaced the bios chip I noticed that the signal of the pin 1 changed to low - 0v. All the other pins remained with similar signals to the signals that I measured with the previous chip.
The end for me but if there's any question from anybody that's facing the same issue, I'm ready to help if I can...

Re: Dead hp dv6 (quanta ut3)



1 - 3.352v
2 - 1.0xxv this pin has as strange value compared to what you've said
3 - 3.349v
4 - 0v
5 - 0v strange too
6 - 2.3xxv strange too
7 - 3.349v
8 - 3.352v

Should I conclude that I have a bad bios chip?...

Re: Dead hp dv6 (quanta ut3)



You're right. It seems an EC problem because i noticed too that the SUSON is low level on this motherboard when it should be high. What was confusing for me was the fact that the EC RST has the # symbol and when a signal has this symbol it should be low level and on my Mboard it's high. But I'm just a noob and I have already replaced the EC.
But atending to what you've said about ec reset I assume that the reset should be just a low level pulse. Am I right?
I'm sorry for my questions but I'm just a noob and in Portugal there's...

Re: Dead hp dv6 (quanta ut3)

Hi. I'm having a similar problem with a Quanta OP6 board of a compaq cq61. And had this exact problem lately with another 2 MBoards of another hp dv6500 - Quanta at3.
I had the 3920_rst# with high level 3.3v in all the faulty MBoards - when it shouldn't, because it should have low level signal, i think so - and I had 8.7 or 7.x volts in the +12VALW signal. I think it could be some kind of common fault on HP laptops.
I'm trying hard to find the fault as you but with no luck until now so if you find the solution let us know and I'm working...