Re: Pioneer PDP-433pu

oh and the working board for 133...

Re: Pioneer PDP-433pu

0.1 ohm and the 0.47 has done been removed from the board but the red is where they go...

on this set it has blown 2 resistors R133 0.1 ohm and the 0.47 ohm by the R224 resistor everyone seems to try and find the weak link but ends up just replacing the psu but i would like to find what is blowing the 2 resistors anyone on the forum ever played with one of these sets without buys new board
i seen the new boards has a few new parts like few of the resistors are now box type cant really tell what they say pic one is my board pic 2 is the new board for 133 bucks with new parts on it...

This tv will not come on when you plug it up you hear something like a squeal it will do it about 3 times kinda like a relay would do when they click on an off a few times so i started replacing alot of things still didnt help as there is alot on this board iv done most caps few resistors and the transformer

i have the same power supply on my desk that i took out of another tv just like this one but some of the parts have diff numbers like the transistor in the tv says (ViPer20 30V332) think its a volt reg and on the other board the transistor/volt reg says (Viper20 CC04c v3 MAR...

Re: dynex dx-l32-10a dead power supply

yeah the batt is 2 days old yeah 200v 470uf it dont say dc but im sure its dc or the meter would need to be set to ac

Re: dynex dx-l32-10a dead power supply

this cap is on the hot side this guy has the same board posted with photos [url]https://www.badcaps.net/forum/showthread.php?t=21532[/url] anyways this cap keeps giving bad readings its will say 68 volts ill discharge it & plug it back up & it will give a reading of 118 volts so i discharge it again & it will give 178 volts so i think its badRe: dynex dx-l32-10a dead power supp...?t=21532[/url]

nvm

Re: dynex dx-l32-10a dead power supply

hmmm i have a cap thats 200v 470uf a x f (PET) i know it would be wise if i keep it in the same uf and go over abit in the volts but think i could use one of these 200v 560uf GU (M) Or 200v 680uf
some seem to think it would be fine to use one but i didnt wont to try it yet with out asking again i am running low on money right now so it couldnt hurt to ask

ok so the power supply on my tv is dead
i have 5 other boards that go to other tvs with busted screens
i was thinking maybe i could Make one of the other boards work with my dynex dx-l32-10a tv
it looks simple they both have the pins labeled
it looks as if i could just cut some wires put them to the right pins 12v /pon /gnd /ect...
would this work ? what do you all think? this dynex does not have alot of wires/plugs looks easy
yes i know i could order one but what fun would that be