Re: Insignia NS-L26Q-10A Won't turn on

I plug it in and get 350v. when i hit the power button it doesn't flash to indicate that it is turning on / warming up just keep the solid standby light on.

Re: Insignia NS-L26Q-10A Won't turn on

Here are 2 more pictures I am going to sit down and read that pdf right now.

Also in your post is says that 12v is for the speakers and 24 for the back light. I had neither 12 or 24 volt. but do I only get 12 or 24 once the TV receives the power up signal from the main board? Unless I am reading my meter wrong I have it set at 20DC getting 2.26

Also Just for kicks i removed the mainboard to look underneath and saw this. I was pretty careful so i am pretty sure is must of been like that from the factory but was...

This is my first post so I hope I don't screw up too much. I had a couple of electronics classes in high school 13 years ago so I am pretty much a noob so forgive my noobness.

OK, I came home one day to turn on the tv pushed the power button and walked off. when i came back it wasn't on thinking i missed the button i pushed it again. The light flashed blue i think and then went back to solid red. i pushed the button again and it just kept flashing red(I said think because i don't remember if red flashed first or blue). after a few min. i pulled the power to "reset" the...