Re: Samsung Syncmaster 225BW
It can be done with that....
zwoeger
New Member
Last Activity: 12-22-2012, 02:23 PM
Joined: 10-03-2012
Location: Dordrecht Zuid-Holland
-
Re: Samsung Syncmaster 225BW
I think this way the EEPROM will be reset....Leave a comment:
-
Re: Samsung Syncmaster 225BW
Somewhere in this topic is the answer I used.
1. Press "down arrow" key.
2. Hold down the "enter" key for 10 seconds.
3. Turn off and back on. The redness disappears.
Hope it helps you too.Leave a comment:
-
Re: Samsung Syncmaster 225BW
I adviced to ad a little 60/40 lead solder to the solder points before desoldering the old caps that way it's easier to romove them because the lead free solder is hard to work with due to a higher melting point. Same for soldering in the new ones.
Since you use a high wattage soldering gun I gues you won't need to do that. Be carefull though with that gun you wil easely heat things to much up. You better use a 30 à 60 w soldering iron.Leave a comment:
-
Re: Samsung Syncmaster 225BW
Follow up.
When I checked the readings in the service menu last evening powered up and one back light showed in the miljons of houres. I then did set everything to zero but the panel change went to 2 .
This morning when I powered up everything the screen showed green only so I repeated the steps as mentioned in my last post but added step 3. Screen went back to normal and everything in both menus was reset exept for the panel change.
The monitor however doesn't start up right away after a power down. So to get into the boot...Leave a comment:
-
Re: Samsung Syncmaster 225BW
Well tom66 I did a search in the thread on eeprom and found this:
1. Press "down arrow" key.
2. Hold down the "enter" key for 10 seconds.
3. Turn off and back on. The redness disappears.
Point 1 and 2 did the trick.
Everything seems to be alright now. Strange readings in the service menu though. Will look in to it further tomorrow.
You guys are awsome. THNX!!!Leave a comment:
-
Re: Samsung Syncmaster 225BW
Thanks for your reply.
Don't know how to enter the service menu without the menu and brightnes buttons working. I tought the procedure is setting contrast and brightnes to 0 and pushing the power button 5 secs.Leave a comment:
-
Problem solved see reply #566
About my 225BW. Manufactured april 2007 in Slowakia. Powerboard rev 2
One day the menu button didn't work anymore. The on/off button didn't work always anymore too.
So I left it on permanently. The monitor did go in stand by and the power button got to blink.
I did get a normal screen when I started up my pc.
The presets/down button worked and I could use the brightness/up button to choose.
Pushing the brightness/up button without te preset menu resulted in this screen:
...Last edited by zwoeger; 10-10-2012, 12:58 PM.Leave a comment:
No activity results to display
Leave a comment: