Thank you for the reply.


So here is 3 pictures, The 2 of the board I didn't take the tape off at that time because I already had a picture of the chip....

Here is what happens with Putty from Camera module. I have tried to stop it but it just gets to the successfully part and then fails after so long restarts to try again. I can ping the default IP address but no open ports and nothing acting like it is trying to do a pull off port 69,
[ATTACH=JSON]{"data-align":"none","data-size":"full","title":"Screenshot (279).png","data-attachmentid":3617708}[/ATTACH]...

So have a camera that came with CEEN firmware and when trying to add in USA Firmware the camera is now bricked.. I have looked at the SoC in the camera housing. It has a few and they were not related to the camera it self so I removed the camera module, wanted to see if it was setup like some of the other cameras that I have repaired in the past. This PCB don't have any clear USB or Reset pads, Connecting a USB to Serial I get very little data and shows that it is FW dead.. I can't stop UBoot I have even tried a script that has some expected key strokes and this also fails.. At first I thought...

Hello and thank you, Look forward to learning from others here.....