Re: Confused cap values during removal- best fix?

I went ahead and replaced the four with 1000Uf/25V Panasonic FMs from DigiKey. The total cost with shipping for these and a few others was about $13. The 1000s were a little larger than the 470s, but I got them in just fine and they work great. The display works like new. I just wanted to say thanks for all the great advice.

Re: Confused cap values during removal- best fix?

Definitely it is on the power supply card.

Which is likely to have run hooter? the 25V 470 uf or the 10V 1000 uf?

Re: Confused cap values during removal- best fix?

Thanks for all the great advice. I appreciate it.

I have studied the board closely and there are no printed markings that I can find that would indicated what goes where. However, the board is slightly darker on two of the location markers than on the other two. It looks as if these two had been at a higher temp than the other two. Would I expect either the 470 or the 1000 uf caps to run hotter? If so, I think I could confidently place them in the two darker openings.

There are marks as to what side...

I am attempting to repair a power supply for an LCD display. It failed to power on and there were 6 bulging caps that I feel confident are the problem.


4 of the 6 were in a row close together. I removed them all, without realizing that they were different values. Now I am not sure which values go into which place on the PCB. 2 were 470 uf / 25v and 2 were 1000 uf/ 10v. They all four appear identical, other than the markings.


I am trying to figure out my best plan. I cant find any info online about this particular PCB (TDK- model XAD819AR). I have...