Re: Replace 47uf 35V cap with 47uf 50V cap?
Okay thanks for the reply! I'll make sure. The ones I'm replacing are capxon kf
The ones i'm using to replace have higher ripple. for the capxon it says 1.5 impedence, and for the ky for impedance it says for 20C 0.7 and for -10C 2.8 what does that mean?
CuriousD
New Member
Last Activity: 10-21-2012, 07:28 PM
Joined: 09-13-2012
Location: California
-
Last edited by CuriousD; 10-21-2012, 07:23 PM. -
Replace 47uf 35V cap with 47uf 50V cap?
recapping a monitor with bad caps. i shouldn't have any problems doing this right? i don't have any of the 47uf 35v caps with me -
How to tell polarity of X and Y caps?
This may be a very stupid question but how do you know the polarity of the X and Y caps and also on the PCB? Coils as well... I hope I'm not missing something super basic
-
Re: Good Fan Brands
I just found some fans completely seized, the brands are: T&T, Icy Dock, and one that just says "Sleeve bearing" out of an L&CLeave a comment:
-
Re: replace capxon with chemicon lower uf?
Thank you very much for the replies
Here's a picture. The red X is the cap that is dead and the one with the red dot is a cap of the same capacitance and voltage that I will also replace. Also gonna replace those brown capxon's cause they probably don't have much life left!...Leave a comment:
-
Re: replace capxon with chemicon lower uf?
yeah, it takes a regular power cable like for a desktop computer. the power supply in it says "DC Output: +12V===5.0A" So a 16V cap should work on the mainboard? I can post a pic if you want.
Although on the power supply, i think i should do a preventative recap by replacing the capxon's on the secondary that are "good"
...
Leave a comment:
-
Re: replace capxon with chemicon lower uf?
oh okay, so they're just really unreliable
How do I know if the input is 12V or lower? do i look on the specs of the switch's power supply or on the bottom of it? all i can see for input is 100-240VAC?...Leave a comment:
-
Re: replace capxon with chemicon lower uf?
aren't capxon usually over spec'd though? would it be possible to go up on capacitance and ripple, but down in voltage to like 16V? thanks for the useful link!Last edited by CuriousD; 09-13-2012, 01:32 PM.Leave a comment:
-
replace capxon with chemicon lower uf?
hi, i have a switch here with a dead cap on the main board. It's a capxon kf series 470uf 25V. i dont have any of those caps but i do have a 330uf 25V KY cap. should that be good enough? the capxon cap has 1200 ripple and the KY has 865 ripple
No activity results to display
Leave a comment: