Re: Trying to re-cap my SamSung syncmaster 920wm
I got to remove the tape, and I have the board, Might need help locating the blown caps. I have deducted that the ones that are slightly puffy are the ones that need to be replaced because I assume the battery acid is being blown outwards. Any thoughts? picture following.....
[url]http://imgur.com/a/tqcv3[/url]
[url]http://i.imgur.com/3XCNS.jpg[/url]Re: Trying to re-cap my SamSung sync...ting the blown
BenDevos
Member
Last Activity: 08-18-2012, 04:01 PM
Joined: 08-12-2012
Location: ontario
-
Re: Trying to re-cap my SamSung syncmaster 920wm
Heres a picture of the connector, nothing underneath and those tabs dont pull it out. I think that I will have to use a blow dryer and get rid of the glue. If you guys dont have any other suggestions
[url]http://imgur.com/uakYS[/url]Re: Trying to re-cap my SamSung sync... <br /> <br />Leave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
I have removed most of the screws, the problem is removing the tape connector between the board and the LCD screen. It seems impossible to get off without ripping itLeave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
Yeah, I have already done that. Its just sitting in the socket, no clue how to disconnect. Is there no flap or anything? or maybe a pull switch?Leave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
bumpLeave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
I have no clue how to remove the tape connected from the LCD panel. Its like stuck there, no clip or anythingLeave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
Yeah, the actual screen is still attached to the board. So it is difficult to take pictures with. I had to go to work in about 30 minutes so I thought i'd post those for more advice, for when I get back and I want to remove the screen.Leave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
I have removed the plastic chassis and I don't really know how to remove the tape connected to the screen, the two wires on the left I have removed....Leave a comment:
-
Re: Trying to re-cap my SamSung syncmaster 920wm
Thanks for the quick responses, I will begin removing the frame in a few moments, once I reach that step I will send more pictures regarding the machinery inside the monitorLeave a comment:
-
Trying to re-cap my SamSung syncmaster 920wm
As I have browsed around these forums looking for a way to fix my Monitor, I have come to the conclusion that I need to replace the capacitor.
I look to disassemble this piece of machinery, but I have no idea how to properly disassemble, If it is done wrong I can permanently damage my monitor.
I have removed the stand and I have gotten to the point where I see up to 3 entry points. I have deducted that these are the most probable entry points
[url]http://imgur.com/a/W2RRI#0[/url]
Can anyone please guide onto how to open the monitor...
No activity results to display
Leave a comment: