Re: Buying Caps - Need Assistance
Is there any downside or danger of using the highest ripple current possible?
RangerMankin
New Member
Last Activity: 08-03-2012, 10:32 PM
Joined: 07-30-2012
Location: Sparks
-
Re: Panasonic G20 Failure :/
Which is to say: Thanks!
...
Leave a comment:
-
Re: Panasonic G20 Failure :/
Got the SC board in, replaced it. Perfection!
I got my multimeter in but didnt use it as it came in at same time as SC board. I'm now repairing my SAMSUNG LNT4061FX/XAA LCD television that has 4 bad capacitors.Leave a comment:
-
Buying Caps - Need Assistance
I'm on the digikey website and I've slowly narrowed down the capacitors that I need. The only stat Im not sure about is Ripple Current and impedance.
Here is the order page:
Is the ripple current a capacity? That is, as long as its high enough it should be fine?
Does impedance matter?
This is for replacing the capacitors on my SAMSUNG LNT4061FX/XAA LCD television.
Thanks in advance!... -
Re: Panasonic G20 Failure :/
Also ordered the SC board based on the Ops situation, the smoking, and I got impatient, lol. I'm going to try it when it comes in next week. I'll also run the tests as the multimeter should be here well before the SC BoardLeave a comment:
-
Re: Panasonic G20 Failure :/
I ordered the digital multimeter from Amazon, I'll report back when it gets here on Thursday.Leave a comment:
-
Re: Panasonic G20 Failure :/
Hi Tom66
I had the same exact issue listed here and followed all of the steps for dianosing that you laid out. Only issue is I don't have a power meter.
That being said all of my results were exactly as Falco21's. One thing that I did notice was that when I disconnectd the SC board and turned it on there was a little puff of smoke that came from the general area of the SC board.
Are the chances that my issue is the SC board as well?Leave a comment:
No activity results to display
Leave a comment: