Re: Messed up Solder Job

Alright, attached are the close-ups.

From the earthring to:
Positive - Mostly open, if I wiggle it I can sometimes find a spot or two where it will show continuity (short)
Ground - Shows full continuity (short)

The second test showed open, but from the pictures showing the traces it looks like it goes up near where I scraped off the trace. Checking from the through to the exposed trace shows continuity.

So it looks like it's just a problem with that positive terminal. Checking from the earthring...

Hey all. So I bought a Hanns-G HG281D monitor from a guy a couple months ago, it was broken, he replaced a couple caps, then sold it to me. Well, after a couple months it started giving me problems so I found these forums and when it finally gave out I recapped the logic board... well... tried. Turns out he used more junk caps that failed and not only that, when he replaced them he messed up the board so trying to work around what he did was a pain... Plus I don't solder regularly so my first couple solders weren't that great... I replaced the ones I figured were the problem, started the monitor...