moshu
Senior Member
Last Activity: 07-28-2025, 04:04 AM
Joined: 10-23-2024
Location: .
-
What I/O file? I've read W25Q128JV chip (bin file is above, post 14), is that not enough?... -
Any help here please?Leave a comment:
-
hi all,
I have a Lenovo E15 Gen1 with Bios Password. Please help to remove.
SN: PF2MFBRZ
Type 20RD0011UK
NM-C421
I read U2101 and attached here.
I've used Lenovo autopatcher but it takes long to generate the image and is the same as the original...Leave a comment:
-
hi all,
I have a Lenovo E15 Gen1 with Bios Pasword
SNP: F2MFBRZ
Type 20RD0011UK
I read U2101 and attached here.
What is the method to unlock this? Does Lenovo autopatcher will work?...Leave a comment:
-
Fixed eventually.
I've compared the bin file after flash with original one and was 100% the same, so I've tried again to patch using RCUnlocker and eventually the dumped file was different. Loaded that file into chip and worked...Leave a comment:
-
Hello Everyone
Pleas ehelp to unlock this bios
HP ProBook 440 G6
Serial Number 5CD01987T8
SKU Number 5TK14ET#ABU
System Board CT Number PHVQV118JDP3I9
I've try RCUnlocker, created an unlock bin file, but after flash, password is still there....Leave a comment:
-
here are some pictures.
Good Luck...Leave a comment:
-
I've used T48 (I am looking to buy a Vertyanov Successor Programmer or a svod4 programmer but dont know which one to pick and where to buy from ; I will appreciate if you can help here too).
With T48 before programming, there is an erase step which took ~100seconds.
On this laptop, I've programed the main chip without removing the chip from motherboard and connected the CMOS battery otherwise an error in the verify stage would appear.
One think I will try is to remove the main chip on the motherboard and try try again.
First laptop I program both chips...Leave a comment:
-
Eventually I did and Laptop doesnt boot...Leave a comment:
-
I've flash the main chip, hopping I will not have to flash the SPI chip (is not easy for me to attach wires or removed from motherboard) and now laptop doesn't boot. There were several attempts to start (looking on the power LED) but nothing on the screen.
Then I've flash both chips but still nothing is happening.
When I plug in the power cable, CapsLock LED and power LED (key) does light 4 seconds, then power LED (key) turn off and NumKey LED + LED from charging port, light for ~2 seconds then nothing else is happening.
With or without DDR same behavior.
...Leave a comment:
-
thanks, I have those information as well, except MAC address.
If the bios version is not new (08/11/2022), can I only patch the main chip?...Leave a comment:
-
Thanks rex98. I confirm it is working fine.
Took me almost half a day to to write the chips because is not easy to me to unsolder them from MB and put them back without damaging plastic around them.
What would be the bios version that will require patching only main chip?
also to put original DMI I was using BCU but I was not sure if I could use the original one to write the settings or only some settings? What do you recommend?...Leave a comment:
No activity results to display
Leave a comment: