Re: AMD Radeon RX 570 MSI Armor - not detected, fault finding
Hi There, hope you doing well.
Did you find the root cause of your problem?
I´ve the very same board with the very same issue.
Any guidance?
Thanks!...
bajinchi
Member
Last Activity: 02-07-2023, 01:47 PM
Joined: 07-05-2012
Location: Buenos Aires
-
Re: Asus GTX 750 ti OC 2GD5 Vram Fault but MATS didn't detect it
Hi, the software are in the video links, check it out.
I´m just downloading it.
Thanks to the author of this post for sharing!
Regards...Leave a comment:
-
Re: Schematic / Boardview MSI B450 Tomahawk Max
Hi! Here are all the BoardViews for MSI B450 Tomahawk Max for all Rev´s
Feel free to use and share.
Regards!...Leave a comment:
-
Re: GTX 1070 Dual 8GB - Short Circuit on 3.3v Line
try isolating the circuit removing fuses and 0 ohms resistors and check whatever is attached to that line, could be dead GPU, but maybe something else shorting that line tho. If you have a thermal cammera, use it, if not, with patience look for what is heating up somewhere in the pcb, if you have DCPS, feed that line with it and tell us how many amps are being draw.Leave a comment:
-
Re: GTX 980 Artifacting even after ram chip swap and core reflow
no broken traces ni the pcb? voltage normal in that bank?Leave a comment:
-
Re: Asus Dual RX480 04G component identification
Measure both pads of the PCB, if one goes to ground, probably is filtering and work without it, unless it´s bootstrapping a data line...
That resistor seems to be as a shunt, maybeLeave a comment:
-
Re: How to program IR3567B and similar?
Could be that just when replaced with a new one, when the graphic card is working again, could be programmed after with the OS working and not before?
And yes, you should get parameters from a working one, or maybe the OC software can program it too trying to OC or Stock the GPU?Leave a comment:
-
Re: Gigabyte 1660 Super not detected
Thank you a lot! One of the AND logic gates wasn´t getting a signal to make an output, so I bridged the output to 3.3V and I got 1.0V (PEX I believe) and other voltage output more.
But doesn´t still get the 0.8V for the GPU core.
So checking the board under miscroscope foundd that R555 was missing... it was placed in this pcb near the holes for the screws, seems the user did a maintenance and ripped that 0hms resistor off, I put a new one and then got 0.8V for GPU, then I remove the jumper in the...Leave a comment:
-
Re: Graphics card Schematics and Boardviews
Hey, did you find the boardview or schematic for this video card? I´m looking for it too.
GV-N166SGAMING 0C-6GD
Thanks...Leave a comment:
-
Re: Gigabyte 1660 Super not detected
Hi Guys, same here. Have 1.8V at U15 and nothing on U13 PEX.
This kinda getting complicatedLeave a comment:
-
Re: Graphics card Schematics and Boardviews
Hey! Did you find it? I´m looking for the same and nothing. Thanks!...Leave a comment:
-
Re: Lenovo Yoga 13 - Schematic Needed
I´m in the same boat, anyone got the schematic?Leave a comment:
-
Re: Apple Mac pro 13" A1502 820- 3476-A no power, need schematic and boardview
Thank you dude!Leave a comment:
-
Re: Asus x202e need bios dump.
Thank you!!!Leave a comment:
No activity results to display
Leave a comment: