TV is working great. Issue was EC210 and just replaced it and all else seems to work fine. Thank you All.

super, thank you.

Thanks again....But pin 3 in con301 and pin 1 in con302 are just connected to each other...they dont seemed to be connected ato any thing on the circuit board. I am getting 240-290 on the other pins when ready to PCB grounds. Again the pCB is not on the TV, it is stand alone when i do these readings.

Thanks.... however how do pin 3 in con301 and pin 1 in con302 function in the circuit to get the voltage needed by the LED lights?

I see an R348 near the LED connector but the rating on the board schematic says NC-0R. what does this mean? I dont see the resistor (probably tucked under the transformer) but I am getting an open circut when I measure it. any ideas
[ATTACH=JSON]{"data-align":"none","data-size":"full","title":"image.png","data-attachmentid":3330105}[/ATTACH]​I see an R348 near the LED connector but the rating on the board schematic says NC-0R. what does this mean? I dont see the resistor (probably tucked under the transformer) but...

I can not do test post 9. I have already replaced the capacitor but would like to know how to test the board to ensure the capacitor was the only issue. I dont have the TV right now, just the power board on a bench and the power cord.

What do I test & how to check if the board is working or not?

I have already changed EC210, old one was a bit bulged. I have the board out on a bench not connected to the main board. How do I test to see if issue is fixed or not?. When connected to power I am still not getting any voltage reading on LED connectors, not sure if I should. Thank you I found C338. BTW R355 in on the back of the board near the IC. I am not able to find R002.

I have same issue. are these readings with the mainboard and LED connected or without. can you show location of R355,R002,C338 on the board and why did you change them?