Schematic and boardview if needed

[URL]https://www.badcaps.net/forum/troubleshooting-hardware-devices-and-electronics-theory/troubleshooting-laptops-tablets-and-mobile-devices/schematic-requests-only/3524880-asus-fx505dd-rev-2-0-boardview-proper-fz-file[/URL]https://Schematic and boardview if n...-fz-file[/URL]

Update:
- Confirmed 32Khz at X2401, but can't confirm the 48Mhz at X2402 (Out of range, cheap scope picks up something oscillating but can't measure it).
- Jumped J9301 test jumper to enable SUSB#. This gives 12VS which then enables 1.8VS and 3VS.

No I haven't checked it. Might be time for me to buy an oscilloscope...

- VBUS_ON output (output from EC)
- Working LED indicators (output from EC)
- Working BQ controller input mosfets
I [I]assume[/I] it to be working based on these, is this a poor assumption?No I haven't checked it. Might be time for me to buy an oscilloscope...

- VBUS_ON output (output from EC)
- Working LED indicators (output from EC)
- Working BQ controller input mosfets
I [I]assume[/I] it to be working based on these, is this a poor assumption?No I haven't checked...

Thanks for your input, I forgot to include the measured inductor resistances I have taken:
INDUCTOR/OUTPUT = OHMS
L8100/5V0 = 16.3K ohm
L8101/3VO = 126 ohm
L8002/VDDCR_CPU_SOC = 4.9 ohm
L8001/L8002/VCORE = 3.3 ohm
L8201/0.9VO = 92.5 ohm
L8300/1.2VO = 93.2 ohm
L8700+L8701/NVVDD = 0.7 ohm
L8900/FBVDDQ = 96.5 ohm
L8800/BAT_R = 31.85K ohm
L8401/1.8VO = 30.7 ohm

And the ones as requested
3VS = 3.37Kohm (at Q9106 mosfet)
5VS = 0.95Kohm (at Q4806) (also, 12VS = 10Kohm)
SUSB#_PWR = 4.4Kohm (at D8325 pin2 -...

As per title, when battery is connected or jack connected: keyboard light flashes once but cannot turn laptop on. Holding power button for 10 seconds then the KB backlight will flash again. Unknown history and signs of previous repair (jump wire from CMOS battery holder positive terminal to R2453, presume broken trace under it)

Thermal camera at board, 3 points warming up (not hot, just warm). CPU, BQ chip and ethernet controller. I guess this is OK??
- Ethernet chip I guess is powered for wake on lan functionality?
- BQ chip is driving input mosfets
- CPU warming...

Sick of trying to diagnose using a PDF boardview, and the other FX505 boards don't match. Found the correct one finally. Copy of the schematic too so it's all in one place....