jin148
Member
Last Activity: 07-21-2024, 03:45 PM
Joined: 06-13-2024
Location: Sacheon-si
-
Proper temperature control is important. And I think I need to apply only a very small amount of solder. I'm a beginner, so it didn't work well because it was too small to do with my hands. When I used a heating gun, the difficulty level was easier and it stuck more firmly. Thank you all. I won't give up and will try again today. -
Thank you for your answer. Is this correct order of heating it with a soldering iron first, then applying flux, then adding a little lead, then placing the element and heating it with a heating gun? It would be better to do it one by one. If I did it all at once, the elements stuck together.Leave a comment:
-
I tried soldering the 0201 of the Powercolor RX6600 GPU chip.
The problem is that lead needs to be applied to the lower surface, but the fillet on the side caused interference. It didn't work well with the soldering iron, so I applied a small amount of welding cream to the lower copper surface and tried using a hot air gun, but it failed. Is there a better way?... -
Thank you for your reply. I separated them, but the resistance values of all 5 were not measured. Isn't this a resistor or a capacitor?Leave a comment:
-
Thank you for your reply. Nevertheless, I'm thinking of trying it with a heating gun. It's interesting....Leave a comment:
-
Can this rx6600 GPU be repaired by soldering?
It's an rx6600 GPU. I tried to attach one of the fallen resistors. The result was failure. They all fell off. I'm not even sure what the resistance value is. When connected, 32 and 42 were measured. The strange thing is that after I removed it, the resistance value was not measured. The resistance was too much. It's small, but is it something that can be done with a soldering iron?...
-
It's an rx6600 GPU. I tried to attach one of the fallen resistors. The result was failure. They all fell off. I'm not even sure what the resistance value is. When connected, 32 and 42 were measured. The strange thing is that after I removed it, the resistance value was not measured. The resistance was too much. It's small, but is it something that can be done with a soldering iron?...
Leave a comment:
-
I want to know the resistance value of the missing parts of the RX6600 GPU.
No need for a circuit diagram, just tell me the resistance value. Thank you.... -
만나서 반가워요. 저는 한국인이고 45세입니다. 자가 수리를 위한 부품의 이름을 알고 싶어서 가입했습니다. 감사합니다.Leave a comment:
No activity results to display
Leave a comment: