Re: Dell Precision 3570 - Help With Component Identification!

Never Mind i got it straightened out!

Thanks

Re: Dell Precision 3570 - Help With Component Identification!

Ok i did a close up of one other one here and then there is some numbers on the heatsink assembly that may just be for the heatsink assembly...

Not seeing anything else like on most boards i mean this board is only a month or 2 old so not to sure... Where else to look removed all plastic black tapping and looked and looked ill keep at it...

Attached is what else i can find!

Thanks...

Re: Dell Precision 3570 - Help With Component Identification!

This not it here i had in a picture the only stuff im seeing

Thanks...

Any buddy no what this oscillator is i believe it is as there is a HZ a little below it long story short the stenciling on this board is off and i should of took pictures while removing the winbond chip on top as the dot on the board is not correct and caused this SENBD1 component to go up! And of course i have put original bios chips back on and no picture!!! (Im smart like that i use to sets of chips) i saw the smoke first hand this is the guy plus you can see the pin hole

10 Pins visible on on side only! no markings... Maybe a schematic or something any help would be great...

Re: BGA rework station - suggestion

Sup Xbox didn't know you where on here lol

I started BGA about 18 months ago i can know do pretty much any laptop no problem!
Reflows will not work what so ever because of the epoxy used around the BGA chips.

Also as a note with he Nvidia series chips anything made befor Data code year 09 has to be replaced as the chip it self is defective and you will receive the same problem if using old lead free solder or new leaded solder. Don't get me wrong the leaded solder will hold up better but the defect is uneven...

Re: Panasonic TC-P42s1 10 blink SS board bad!

Hello,

Not sure if this is ok i have this same tv and same problem but not the SS board as i have followed the attached flow chart and see the red circle where i get stuck...

I do not get 10 blinks i do not get 6 i do not get any the Power LED comes on solid then the TV just shuts off that is it no blinks no nothing.

Would that be the A board or the P board causing that issue?

Any help would be great i could not make a new thread so i hope posting to this one was ok as i think...

Re: New Members - please post your introductions here

Hello all trying to get my account going love all the info has helped alot without evening having to ask but now i need to ask so im posting a Hi there message here in hopes i can then post a question!

Thanks All!