Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Thanks both. Yes, I intend to use the STLink with the header pins at some point. I added them when I did the grounding mods for the tip and case (There was already a ground lug on the back panel, but with the case anodising it wasn't being conducted around the case). The ground pin of the 5 pin iron connector wasn't connected to anything either, meaning the soldering iron tip was floating.
Leave a comment:
-
Thanks both. So presumably their firmware is making use of this extra hardware, at a minimum to determine if the cartridge is fitted and working. Does the custom firmware determine the cartridge state in a different (perhaps inferior) way?
I'm basically just trying to decide if I should try the custom firmware or not. There is always the risk of bricking the unit or not being able to go back to Quecoo firmware. But I do have an ST-Link that says 'use me' on the box (well I think that's what the Chinese says)!
Thanks again.
Leave a comment:
-
I've just (today) received a Quecoo T12-958 that looks to be this version (3.2 + 3.2S) and am reading this thread with interest. Thanks for the interesting posts. 🙂
I had planned on installing the custom firmware. But if this Quecoo/Quicko is monitoring heater current, does it mean that the custom firmware should be avoided because the stock firmware is better?...
Leave a comment:
No activity results to display
Show More
Leave a comment: