@dbtx: Thank you so much for posting it.
For me it was exactly the opposite way!...
0laf
Member
Last Activity: 11-03-2023, 07:47 PM
Joined: 10-14-2007
Location:
-
Re: Graphics card Schematics and Boardviews
@dbtx: Thank you so much for posting it. For me it was exactly the opposite way!...
-
Re: Graphics card Schematics and Boardviews
The P2010 reference schematic should be helpful as well. A kind fellow already posted it:
[url]https://www.badcaps.net/forum/showpost.php?p=1081325&postcount=307[/url]
[U][B]Own request:
[/B][/U]
Looking for close [B]reference GTX 660 boardview[/B], like:
[LIST][*]MS-V287[*]Asus C2030P[/LIST]
Basically, does one of you have [B]any[/B] other GTX 660 other than the [B]Asus GTX 660 Draon Direct CU[/B]?...Last edited by 0laf; 05-01-2023, 01:28 PM.Leave a comment:
-
Re: Asrock K7S8X R3.0
another question: there are some more TAICON caps on the ASrock board that still look ok.
should i replace them aswell?
thanks for your helpLeave a comment:
-
Re: Need help about my MSI K7N2 Delta ILSR
hi rayken,
65 °C isnt that nice but not really critical. shouldnt cause instability.
have u changed anything else?
btw kikkoman, u ve got a pm
...
Leave a comment:
-
Asus V8440 (ti4400)
hi again
this time i have trouble with a gfx...
when i put it in an AGP slot and try to boot i get no video signal.
additonally the ti4400 chip does not get hot (i tested without heatsink).
i havnt found any visibly damaged parts..
btw i doubt its a capacitor related problem
only sanyo caps..
any ideas?
thanks for helping
olaf... -
Re: Asrock K7S8X R3.0
thx for the replies,
i ll gonna check the caps on the psu aswell
Leave a comment:
-
Re: Asrock K7S8X R3.0
1000uF 6.3V, 10 mm x 12 mm, max. temperature: 150°C, durability: 2000-5000h, esr: 0.08
i m living in austria
Thanks in advance...Leave a comment:
-
Asrock K7S8X R3.0
Hi all
my first post here
found this in my brothers computer,
the mainboard is still working fine in spite of the 5 open caps.
all big brown KZG 3300uF caps still seem to be fine.
well the smaller taicon 1000uF caps are
I guess taicon is a rather bad company?
I will try to replace them, would Yageo caps be o.k. for that? (looks like its rather difficult to get something different in europe)
Btw: would be a temperature controlled (150-450°C) soldering iron enough for that or do i need more equipment?...
No activity results to display
Leave a comment: