lucasbrand
Lucas
Last Activity: 02-28-2024, 06:03 AM
Joined: 02-21-2024
Location: Bavaria
-
The measurement was to ground... -
And as I struggle to find a beginners guide for desoldering chips, what is a good temp for the hot air station to use? Using severals values (slowly increasing) up to 350°C with some flux on the chip didn't get me to remove it with my tweezers......Leave a comment:
-
so what should I do then when the F7000 has been successfully removed?
...
Leave a comment:
-
Ok, thank you! This will take some time as I will have to order tools....Leave a comment:
-
Forgot to quote you
...
Leave a comment:
-
Both sides same behaviour. Started with around 0.7 Ohms counting up continuously....Leave a comment:
-
A1706
Hey folks,
as, even after 24h after my introduction post, I am still not free to create a Thread, I tried to find the most suitable:
I have this dead A1706. Here is what I have checked so far:
• Ampmeter in all 4 USB C Ports: All same, 5.02V, 0.0A, no bootloop
• (Not removing the Power Supply)
• PPBUS_G3H at F7000: 17mV both sides
• PP3V3_G3H at L6900: 0.4mV both sides
• Check for enable at U6903 Pin 10 Test points: 0.31V
I recreated those steps from a video. Now my question: The Voltage for the enable seems... -
Does anyone know if there are any further steps to create a thread? I introduced yesterday I read that I can take up to an hour to haev the feature enabled. 14h ago... 😳Leave a comment:
-
Hey guys, this is just a business informatics bachelor student from Munich, Germany. Looking at a boardview software for the first time 🤫
Leave a comment:
No activity results to display
Leave a comment: