Thank you for clarifying that....

Thanks ...

I tested them with a multimeter when they are still attached to the boards and they all read about 0,5 ohm....

How can I check them when they are still attached to the board? Do I have to remove them to be able to test them?
I dont have a IGBT-checker, just a multimeter. Hon can I test them with my multimeter when they are still attached to the board?...

Yes, I did. And just to be sure I did it once again just now and with the kids not running around making noice I can hear the tv going into test mode. It's like a cycle of different buzzing sounds from the sus boards which is only there when I put in the jumper for the pattern test. Without the jumper it's just a constant buzz. Still no picture or priming on the screen.

Please advise me what to try next.
I have used a IR thermometer to measure the heat sinks on the sus boards after letting it run for about 15 minutes. The temperature on some heat sinks gets raised by just 2...

Hi,

To start with I think I have red every single topic on this forum about the No picture fault on this TV. Seems like a common fault but I just can´t find a match i other forum threads for my TVs fault.

Symptoms:
No picture, not even a little primer.
Unable to check if I have sound since I don´t have any picture to navigate the menu to be sure I´m on the correct input.
When connecting power cable it clicks just like it used to and the red standby light on the front comes on.
When pressing the power button on the front it clicks like it´s...