Just to add, on rear of card: CG413P rev 1.00

Hi, I have quite a lot of GTX 1080 boardview cad files that I found somewhere ages ago, but none of them are close enough to the layout of the card that I have.

There's a sticker on the card that has this on it:

Strix GTX1080 A8G Gaming D212 062820 02365 YV09M2 A04

Has anyone got a boardview for this please? I have a short on the 1V8_AON rail and the FBVDD rail (not the GPU causing it) and using a half ohm device is helping me get closer but I need to see where some vias go to.

Thanks...

Highlighted in red is one of the two 0 ohm resistors that weren't making good contact with the PCB. Despite this boardview showing 3 resistors, only two are actually present.

This caused the 3V supply from the PSU connector to not make it to the various ICs and other parts. Result was no QLED lights, CPU didn't get warm, etc.

[ATTACH=JSON]{"alt":"Click image for larger version Name:\tZ370.jpg Views:\t0 Size:\t301.3 KB ID:\t3242134","data-align":"none","data-attachmentid":"3242134","data-size":&quo...

I fixed the motherboard. There was a supply missing but I can’t remember any of the designations right now, I’d need the board view open on my PC. It was due to a couple of side-by-side 0 ohm links having overheated and no longer making good contact with the PCB....

Hi,

Strange problem. Motherboard was working prior to removing from PC case. Following removal, it switches on but won't POST and none of the QLEDs light up.

I've removed the BIOS IC 25Q128A and have written the latest BIOS to it.

I've checked the CPU core voltage and it's present at 1V.

Still won't POST or show any QLED lights. The boardview is available from this site, the sub-forum to this one. Haven't got a schematic though.

I'm not very familiar with motherboards. Can anyone advise please?

Re: Nvidia MATS help please - 33 errors on two cards?

I've now tried the version by Lord of the GPU and that gives lots of errors on all 3 cards. The test runs as soon as that loads but maybe I need to change some parameters?

Hi,

I'm new to MATS and can only use it after watching a Youtube video, downloading the one he linked to (version 400.184) and running it without changing anything. I have no great understanding of it.

I have 3 graphics cards in the house.

My son's - [B]Palit GTX 1080[/B] used for 3D games constantly.
Mine - [B]Nvidia GTX 1080[/B] not used for 3D games, just basic stuff.
Inno3D [B]RTX 2080[/B] I bought faulty hoping to repair for my son's PC.

Running MATS on my son's GTX 1080 gives a pass with no errors.
Running MATS...

Re: Dell 2407WFPb Monitor - Bad Cap

D19 won't have destroyed the hexfet; D19 is the protection zener, in place between source (ground - unless your source isn't going to ground, in which case the zener will go to ground but not source) and gate in case the MOSFET ever fails, going short-circuit drain to gate, and putting full drain voltage on the gate which would then destroy all of the gate driver circuitry. Instead, if drain voltage gets to the gate, the zener is there to fail s/c and drop the voltage straight to ground.

The failure of the MOSFET may not have damaged...