Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
LED bars arrived today. I made the change and tested it. It works perfectly. Thanks to everyone who helped.
-
OK. Thanks.
I will change it as soon as possible and share the result.
Leave a comment:
-
Now I removed the panel. I tested the LED bars. LEDs on one side did not light up. There are 4 bars in total. Grouped in pairs of 2. I tested the double group of bars I tested one by one. 2 LEDs in one of the bars are faulty. I wonder if this is the source of the problem.
Leave a comment:
-
-
I wrote it incorrectly. I also suspect the back light led bars. I want to be sure of dismantling everything.
Leave a comment:
-
I also suspect the rear lush led bars. I want to be sure of dismantling everything.
Leave a comment:
-
-
Hello,
This is what is stated in the manual.
TWO Blinks---B+ over current protection (OCP) , unit goes to the standby
mode then displays the 2 blink fault. Could be a short in the power supply of
any of the circuits.
When turned on, the backlight turns on momentarily. Then everything shuts down. I tried to measure it with a voltmeter until it shut down. Something like 85v. The voltmeter cannot read quickly until the relay closes.
Leave a comment:
-
SONY KDL-40NX700 2 red led blink problem
When the power is turned on, a snapshot appears on the screen and it turns off. 2 red LEDs are flashing.
I disconnected the power module cable going to the main board. I threw a power on jumper with 3.3 v from outside. The relay is working and there is 12v and other voltages in the power socket.
Where else should I look? All fuses appear to be intact.
No activity results to display
Show More
Leave a comment: