Re: Hanns-G HG281D, LCD Monitor no power
From those directions, the fuses appear to be good. Both read 0.7
Transformers L to R S1-S2, then S3-S4
1. 1142,1147
2. 1144,1148
3. 1161,1169
4. 1159,1167
5. 1151,1159
6. 1146,1152
7. 1156,1164
Greg4050
New Member
Last Activity: 02-27-2012, 12:45 PM
Joined: 02-21-2012
Location: Lees Summit, MO USA
-
Re: Hanns-G HG281D, LCD Monitor no power
I didnt have the LED hooked up earlier. With it connected, it is on. First blue, then orange.
Pin 11 of CN2 reads 0.01
I have attached 3 shots of the inverter. L, M, R for Left, Middle, and Right...Leave a comment:
-
Re: Hanns-G HG281D, LCD Monitor no power
Thank you for your patience. Yes all other pins were zero.
After connecting the signal board, all other pins are still zero and pin 5 is still 5.20.
From the corner of the signal board moving to the right
Pins of U7 read 5.20, 3.32, 0
Pins of U8 read 3.32, 1.82, 0Leave a comment:
-
Re: Hanns-G HG281D, LCD Monitor no power
Counting from the lower right corner, Pin 5 of CN2 is reading 5.21...Leave a comment:
-
Re: Hanns-G HG281D, LCD Monitor no power
Thank, I was only checking the file size. I borrowed this camera, so I had no idea the default was that many pixels!
Pictures NOW attached....Leave a comment:
-
Re: New Members - please post your introductions here
Hello!Leave a comment:
-
Re: Hanns-G HG281D, LCD Monitor no power
I have the x seconds to blank. The led stays on all the time, but nothing else.
I've read this entire post, but I'm unsure if the fix is to recap both boards.
If so, can I get some help with which caps to order?
Pics attached. (ok, not attached... I keep getting errors) First it was no security token, now it just says failed to upload.
I have C8,31,32,33,34 and CS20-28 on my power supply board.
I have a message in to the admin requesting help with the uploadsLast edited by Greg4050; 02-22-2012, 03:52 PM.Leave a comment:
No activity results to display
Leave a comment: