Re: Looking for SMD resistor values
I will do a physical check on the PCB, but I can confirm that the short circuit occurred due to corrosion.
And will check the path with a multitester....
Safrilhg
Safrilhg
Last Activity: 11-18-2023, 12:02 AM
Joined: 11-06-2023
Location: Aceh besar
-
Re: Looking for SMD resistor values
Yeah, iam gonna tested, if the components burn, that's so amazing hahaha....Leave a comment:
-
Re: Looking for SMD resistor values
Thanks for help, But according to your guess, what value is suitable for the resistor. If I 220 ohm....Leave a comment:
-
Looking for SMD resistor values
Hey everyone, this time the question is very complicated, hope there is an experienced technician.
The BenQ g922hdal monitor experienced a short in one of the SMD resistors in the power section.
[ATTACH]317855[/ATTACH]
From the picture I attached, the path leads to the SMD capacitor and to the leg of the LD7560GS IC.
[ATTACH]317856[/ATTACH]
Can anyone help determine the value of the SMD resistor?Hey everyone, this time the question is very complicated, hope there is an experienced technician.
The BenQ g922hdal... -
Re: Look for the resistor value in the BenQ G922HDAL monitor's power supply
Should I use the same ohm value as the resistor next to it?,...Leave a comment:
-
Re: Look for the resistor value in the BenQ G922HDAL monitor's power supply
OK thanks for information, But I will try replacing the resistor first, if it burns again I will check for damage to the line, but in my opinion, the resistor burned because a pin was short-circuited due to corrosion....Leave a comment:
-
Re: Look for the resistor value in the BenQ G922HDAL monitor's power supply
Should I use the same ohm value as the resistor next to it?,Leave a comment:
-
Look for the resistor value in the BenQ G922HDAL monitor's power supply
Hello guys, I had a problem where I didn't know the value of the burnt SMD resistor in the power supply circuit of the BenQ G922HDAL monitor.
[ATTACH]316878[/ATTACH]
In one of the parts, there is a burnt SMD resistor which leads to the LD7560GS IC as shown in the picture below.
[ATTACH]316880[/ATTACH]
[ATTACH]316881[/ATTACH]
How to determine the appropriate SMD resistor value for this condition? Thank YouHello guys, I had a problem where I didn't know the value of the burnt SMD resistor in the power supply circuit of the BenQ G922HDAL monitor....
No activity results to display
Leave a comment: