Re: Hp ProBook 430 g3 not turnning on
Anyone?
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Hp ProBook 430 g3 not turnning on
Well after to much digging around and nothing usefull i accidenatlly shorted 19 volt rail at charger connecter and now the laptop is totally dead.
the resistance on 19 volt rail is about 6 ohm which seems very low to me.
I tired injecting 2 volt with2 amps at current sense resistor and the only thing that gets extermly hot is cpu.
1- what would be typical resistance of 19 volt rail ?
2- how on earth i shorted cpu by accidentaly shorting 19 volt rail on charger connector ?
Regards
Leave a comment:
-
Re: Hp ProBook 430 g3 not turnning on
What else should i check then to find a problem ?
Leave a comment:
-
Re: Hp ProBook 430 g3 not turnning on
Should i have any kind of always on voltage around memory power supply ?
i only have 19 volts on the drain of the mosfet of memory power supply circuit and nothing on the source and gate or at the coil....
Leave a comment:
-
Re: Hp ProBook 430 g3 not turnning on
Thnak you
I have replaced PQ26 mosfet, not sure if cpu is shorted cause resistance around it is 5 ohm which seems to be right.
Are you sure there should not be voltage on bios pins when charger is connected ? then why there is voltage on bios pin pads when chip is removed ?
Im going to test with another bios chip to be sure of this .
Also super io seems to be fine cause it read power button input though when i press power button charger port goes white and also blink orange 4 times then goes off ....
Leave a comment:
-
Hp ProBook 430 g3 not turnning on
Hi everyone
I have got a friend hp ProBook 430 g3 laptop which was not turnning on at all, found a short at 19 volt line which was one of the vcore mosfet AON6370 and replaced it with equivalent mosfet, after that i got 19 volt, 5 volt and 3.3 volt in the circuit but the issue persist and it still the board does not turn on.
when connecting charger it shows white light and also blink orange 4 times and then turns off but voltage are present on the board.
I do noticed that i do not have voltage on pin 8 of bios chip and tried reprogramm it several times and still it does not...Last edited by dimebags; 10-11-2023, 03:05 PM.
No activity results to display
Show More
Leave a comment: