Re: scorch mark on board around resistor
Even if the resistor is the correct value, the leads have probably heated enough that you will have a hard time soldering it.
I would replace the resistor, use a dremmel tool and some epoxy to repair the burned board, and run jumpers to replace any bad traces.
It could have been originally a bad solder connection on the resistor which caused the heating and charring.
Ray
paslug
New Member
Last Activity: 01-25-2012, 06:52 PM
Joined: 01-21-2012
Location: Kennett Sq, Pa
-
Re: Dell E153FPB Back Light problem
Jschiefer, Did you try a different vga cable?
EDIT: Sorry, I just reread your post where you said you tried a different cable and source. My Bad
RayLast edited by paslug; 01-22-2012, 01:46 PM.Leave a comment:
-
Re: New Members - please post your introductions here
Hello all, I found this site a couple of hours ago, and have been reading through some of the posts. I'm really impressed with the patience of the moderators and the thoroughness of the answers.
Thank you for a great resource. I'll be back
RayLeave a comment:
No activity results to display
Leave a comment: