Re: Thermador Oven Controler Dim display
So checked everything again today. Looks like the only thing they replaced on the board were the capacitors. I found one that was loose and not tracing out properly so I soldered some wire to fix that. Checked all the other solder joints that they did but didn't find any problems. Put control board back in and still the F1 error. Tested the temp sensor again for both resistance (1080 ohms) and ground fault (that passed). Unfortunately I can't get anything other that the F1 error on the screen so can't check what temp it thinks it is. ...
Thank you to the guys at HEGE supporting Badcaps [ HEGE ] [ HEGE DEX Chart ]
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Thermador Oven Controler Dim display
Just wanted to provide an update. I sent the board off to a repair place and they repaired it, tested it in a working unit, and sent it back to me. I reinstalled the board and unfortunately I'm still getting the F1 error. Based on a recommendation I tested the thermostat and it appears to be working as it is producing 1085 ohms resistance at room temp which is about right.
I know that this isn't really an open repair forum but any other ideas on what to check?
Leave a comment:
-
Re: Thermador Oven Controler Dim display
Thanks again for all of your help. I was able to order and replace all of the capacitors listed above. Unfortunately my board is still throwing an F1 error so it must be something else. Without a schematic and more patience I broke down and sent the unit off to a repair shop. Will follow up here when they let me know what they found.
Leave a comment:
-
Re: Thermador Oven Controler Dim display
Never Mind on the purchase question. I know I can order them on-line, I was looking for a more local option like the old radio shacks. Looks like there's a micro-center not too far from me....
Leave a comment:
-
Re: Thermador Oven Controler Dim display
I am working on the same board and was able to confirm the following:
Relay /power board
C1 3,300uF 16V, size skinny 12.5x25mm LS=5mm
C5,C8 470uF 16V, size 10x20mm LS=5mm
C9 100uF 50V, size 8x11mm LS=3.5mm
VFD display board
C3 4.7uF 35V
[B]C11 .47uF 50V[/B]
C14 10uF 16V
So where is the best place for me to purchase these small individual caps that meet these specs?Re: Thermador Oven Controler Dim display
I am working on the same board and
Leave a comment:
No activity results to display
Show More
Leave a comment: