Re: ThinkBook 14 G3 ACL BIOS BIN
No soldered to a wson8 to dip8 adaptor pugged into the ch431a...
Negoti8
New Member
Last Activity: 09-28-2023, 01:33 PM
Joined: 08-06-2023
Location: North Shields
-
Re: ThinkBook 14 G3 ACL BIOS BIN
Refuses to erase. I think might be bad, don't know how though...Leave a comment:
-
Re: ThinkBook 14 G3 ACL BIOS BIN
As you mentioned above I am currently doing. Neoprogrammer said it write to the chip but when doing verify I get an error and then reading chip again it reads as a blank....Leave a comment:
-
Re: ThinkBook 14 G3 ACL BIOS BIN
Question here. I'm also using the ch341a programmer. Seems to read the windbond 32mb 256bit fine but refuses to wright to it. Is there limitations to this programmer or is it my fault for doing it at 3.3v without the 1.8v adaptor. 25q256jveq chip from hp board.Leave a comment:
-
Re: HP Probook 640 G5 i5 8th gen Touch screen - Bios Corrupt
Thats why i asked for a bios dump so i can start working on a bios rebuild, i just not sure where all the info is stored in the bios. as for mac address thats easy just the other dmi information...Leave a comment:
-
Re: HP Probook 640 G5 i5 8th gen Touch screen - Bios Corrupt
Yes i have ordered a adaptor board and hoping for the best, but with my luck i might as well order a new chip and try to build a bios for it....Leave a comment:
-
HP Probook 640 G5 i5 8th gen Touch screen - Bios Corrupt
Good day all, Yesterday i tried to create a dump of my bios so i can try to delete admin password. I noticed after every read i got a corrupt dump. (was trying out a new wson8 test lead adaptor). Now the laptop only has a flashing caps lock and no signs of life. Very possible this new test lead caused the issue.
How can i go about rebuilding a compatible bios for the laptop?
Leave a comment:
-
Re: New Members - please post your introductions here
Hi, I came from a very bad background and since 6 years old have been in electronics and computers to get by. I'm now much older and still can't shake to tinker and well sometimes I break stuff by tinkering too much. The fun is to get it working again lol. Short intro as I'm not a person for many words.Leave a comment:
No activity results to display
Leave a comment: