Re: Lenovo E540 no 3/5valw
I have replaced the RT8243A IC twice but every time I get PQ401 and PQ403 mosfets shorted and burned. The IC has no voltage on outputs or very low voltage though VIN 19.5 and ENLDO 3,2 are present.
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
aile2 nm-a161 rev 1.0 schematic
Dear All,
I need aile2 nm-a161 rev 1.0 schematic and boardview.
Thank you in Advance.
-
Re: Lenovo E540 no 3/5valw
I have replaced the RT8243A with a used one, but the readings I got was very faulty even it did not have any short. I went back to the original RT8243A, but I want you guys to confirm [B]if it is safe to run the IC without the caps?[/B] since I have removed the jumpers PJ402 PJ403.
For the pin 13 ENM what is the ideal voltage, should it be 3.3v?
I was planning to remove PR420 and connect ENM with LDO5 to see if the IC is faulty or not. is it a good idea?
Pressing the power btn does not lead to any change though 3vl is present.
...
Leave a comment:
-
Re: Lenovo E540 no 3/5valw
According to the data sheet of RT8243A having 1.2V to 1.8V on Pin 13 will activate the switching mode on ASM==Audio Skipping Mode==Ultrasonic Mode. For the polarized capacitors I have checked and the they have no short. I wonder if I can run the IC without the caps to see for seconds if their is any voltage on conductors, since I cannot get hold of new caps right now.
Leave a comment:
-
Re: Lenovo E540 no 3/5valw
Hi, I have measured all the mosfets before. pq301 / pq302 only the B+ is present on pin 5. For pq303 pq304 no voltage at all.
Leave a comment:
-
Lenovo E540 no 3/5valw
Hi all,
I have an aile2 nm-a161 rev 1.0 board that IO ITE8586 and 3/5v regulator was defective so I Have replaced the IO with a new programmed one, but when I replaced the regulator I did not get the 3/5v on the inductors
and here are the readings from the IC:
1 FB1 0
2 ENTRIP1 0,9
3 TON 2
4 ENTRIP2 1,5
5 FB2 0
6 PGOOD 0
7 BOOT2 4,5
10 LGATE2 0
9 PHASE2 0
8 UGATE2 0
11 VIN 20
12 ENLDO 3,2
13 ENM 1,3
14 LDO5 5
15 LDO3 3,3
16 LGATE1 0
17 PHASE1 0
18 UGATE1...Last edited by Vesko356; 07-23-2023, 04:38 PM. Reason: Attached schematic removed and replaced with link.
No activity results to display
Show More
Leave a comment: