Re: Tannoy Reveal 6D

My issues turned out to be the volume pot, followed the signal around the schematic till i tracked it down.

I usually run them at half volume so for the time being i removed the pot, measured it at half volume (since its a log pot) and replaced it with high tolerance resistors.

They have been working a treat ever since! Sound a bit more confident too, i think the pot was right on the edge even when it was working. Also removed the brown glue gunk as midibob suggested too.

The strangest part is that they now seem to run...

Re: Tannoy Reveal 6D

Hey Midibob,

Also have myself a set of revel 6D's which i'm having some problems with. Sounds very much like a dry solder joint on mine though, i completely lose sound and have to tap the controls on the back of the speaker to get it back. Strangely its starting to happen to the second of the pair too.

Was also a little disappointed on quality when dismantling them. Either way, went over what i thought were all the relevant solder connections but dont seem to have had much luck.

Don't suppose i could also grab the schematic...