kmcbride1981
Member
Last Activity: 11-28-2015, 12:47 PM
Joined: 12-30-2011
Location:
-
Maxent MX42HMP20 snow
I have replaced the power board with the same model# and adjusted the Vs and Va to spec, which are Vs 195 and Va 65. I still have snow just not as bad as before the power supply adjustment. I cannot find the voltage specs and test points for the xsus and ysus. Also ysus has 4 potentiometers whereas the zsus has 1.... -
-
Re: Vizio standby light but will not power on
I replaced the main board and logic control board. I got them for $65 shipped (ebay). Plasma is up and running. Thanks for all the tips and help.... -
Re: Vizio standby light but will not power on
the reddish connector on the end of the main board that goes under the main board chassis.Leave a comment:
-
Re: Vizio standby light but will not power on
pic from another p42hdtv10a
what is this cable? I do not have this....Leave a comment:
-
Re: Vizio standby light but will not power on
There is power going to into the sub power board (121v) and the main power board (121v), however there is none to the power button nor on the main board. So c, d, e, and f should be reading 0V.Leave a comment:
-
Re: Vizio standby light but will not power on
A = 0.134 0.229
B = F43 KA7809
C = 0.000 (has auto range)
D = 0.000 at all contacts there is not a part #
E = 0.000 at all contacts
F = 0.000 at all contactsLeave a comment:
-
Re: Vizio standby light but will not power on
thanks...Leave a comment:
-
Re: Vizio standby light but will not power on
yesLeave a comment:
-
Re: Vizio standby light but will not power on
pics...Leave a comment:
-
Re: Vizio standby light but will not power on
tv will not power on at all, it just stays in the standby mode. pics coming.Leave a comment:
-
Vizio standby light but will not power on
I recently was given a Vizio P42HDTV10A from a friend. When i opened the back I checked the power board and the caps were bad. I went to replace the caps and the bottom of the board was burnt were the caps are soldered. I replaced the board with another. The standby light is orange, but nothing happens when the power is pressed. Any suggestion would be appreciated.
No activity results to display
Leave a comment: