hey there, do you have Zotac 4090? the board 1.8V is somehow different from other board. but I couldn't figure out how.
if you have Zotac 4090 boardview, I would be grateful
McWhitePink
Senior Member
Last Activity: 04-12-2025, 11:07 PM
Joined: 04-03-2023
Location: San Jose
-
Do you happen to have founder edition boardview? appreciate it.Leave a comment:
-
I still believe there is a hardware failure on your mobo. shouldn't be the bios issue...Leave a comment:
-
Thanks a lotLeave a comment:
-
ASUS Strix G17 G713P boardview request
Hi Friends,
I'm having issue with my G17, many power rails are shorting to GND.
Can anyone share the boardview?
board number is 6050A3468901-MB-A01
Thanks in advance for your help -
Does anyone know how much voltage should the optical coupler output? I have two PSU, don't find any short, but it turns off instantly. I'm suspecting the feedback circuit, but don't know what value should I expected....Leave a comment:
-
Boardview required for ASUS M16 GU603
Does anyone have Boardview file for GU603? I have couple of power shorted to GND, but don't know what are these.
Thanks -
Can you please post the schematic here?...Leave a comment:
-
HelpLeave a comment:
-
Gigabyte rtx4060ti 16G ,Help identify the missing components
Hi friends,
anyone have a Gigabyte rtx4060ti 16G version?
Can you please help identify The missing components In The picture ?
Thanks... -
Please try to summarize your TLDR.
I have difficulties to read through all the words.
Did you measure the resistance as frysue36 suggested?...Leave a comment:
-
are you able to monitor the temperature while loading it? Might be throttled by temperature.Leave a comment:
-
Pin 2 in your picture should be GND. you can check it.Leave a comment:
-
Did you try to remove your hard drive and boot? before saying anything is dead, you may need to try everything to get into the bios settingsLeave a comment:
-
When there is low load, why do you expect to have high clock speed?Leave a comment:
-
hot plate is necessary for this case....Leave a comment:
-
You should circle the missing component, I don't know which ones you are refering to. the only two missing components I saw are capacitors....Leave a comment:
-
Remove the RTC battery and short the two pins for more than 10 seconds. or short the CLRRTC pins for 10 secondsLeave a comment:
-
Just the two components? those are capacitors, you can put something like 1uF, it should work, even without those it should work....Leave a comment:
-
Might be the UEFI issue. I don't think anything damaged. you can boot with a USB drive and reinstall the OS to your SSD.
but a BIOS reset may also fix the issue. it's just annoying to mess up with the UEFI.Leave a comment:
No activity results to display
Leave a comment: