I have one of these new Cold Heat soldering iron
See article:
[url]http://www.msnbc.msn.com/id/6151688/[/url]

So far I have tried it for removing some caps from some old boards that I have and it works very nicely. I have not tried an install yet.

I was wondering if anyone here has any experience with using the device.
Thanks
Jayhttps://I have one of these new Cold...ld boards that

Dell Optiplex GX270 has extended warrantee till end of 2007

Dell May Fix them For Free:

We had a problem with one of our dell GX270, it was actually reporting as a thermal event, while researching I stubbled across this in the dell forum

[url]http://www.dellcommunity.com/supportforums/board/message?board.id=dim_other&message.id=295668&c=ca&l=en&cs=&s=gen[/url]

So I contacted them, they got me to visually inspect the caps which one was bulging. So they ordered a new MB and sent a tech to swap it out.
No Charge....