Re: Nichicon HM's or Rubycon ZLH's

Recapped the whole board over the weekend with the HN's for the OST RLX's and ZLH's for the RLP's. Board is working great and holding an overclocking on my E7200 as well. Thanks for all your help everyone!

Re: Nichicon HM's or Rubycon ZLH's

Upon further inspection, the original OST RLP's on the board have specs that are already worse than the ZLH's

RLP, 0.11ohm,730mA
ZLH, 0.045ohm, 1250mA
HM, 0.018ohm, 1870mA.

So it would seem that the ZLH's should be fine to use (unless the board designers totally spec'd the board wrong). Going to try to use a few of the ZLH's before my HM's come in and see if there are any issues. Wish me luck!

Re: Nichicon HM's or Rubycon ZLH's

Thanks! I'll go ahead and order the HM's then.

Hey everyone:

I am planning to recap my Shuttle FG31 motherboard ([URL="http://www.flickr.com/photos/30825931@N06/4577801307/"]picture[/URL]) that has recently start to bulge. I picked up a bunch of Nichicon HN's from Newark and for the 8x 1000uf 6.3/10v 8mm cap listed on the replacement kit here I picked up some Rubycon ZLH's because they were in stock for that size and spec.

I checked the ZLH's specs just now and found that it had almost twice the ESR as the HM's which have now come in stock (still not HN stock).

Should I order the HM's...

Re: DFI Lanparty B / Ultra Infinity (nF2)

Does anyone have experience recapping the NF2 Infinity?

I have a feeling trodas you wrote most of the recapping info on this thread here:

[url]http://www.pclincs.co.uk/Forums/showthread.php?threadid=9156&perpage=15&pagenumber=2[/url]

I've been trying to put all the information from that thread together so I can recap my infinity with Panasonic FM's, but some of the numbers don't match up between the picture illustrating the cap placements and the digikey shopping list.

Could...