Re: The infamous 2 seconds to black
yes led stays on.
and yes i did use low ESR caps
and yes i did measure transformer's both sides and it did match. both was very near 1kOhm
i did check solder joints and now i need to change CCFL to working one's.
vokwok
New Member
Last Activity: 02-24-2014, 09:41 AM
Joined: 09-21-2011
Location:
-
Re: The infamous 2 seconds to black
area you saying CCFL are broken or even one of them is broken ?
what is easyest way to test these CCFL ?
should the monitor stay on if i dont connect CCFL connector's to board?Leave a comment:
-
Re: The infamous 2 seconds to black
I have Fujitsu siemens monitor with same guts like this acer
and problem is also 2 seconds to death.
when monitor is turned on there will be very good picture from computer for 2 secs and then it goes blank. I have replaced all caps and i did measure the transformer and fuses too. could someone give me a hint what to look next?
and i did use vga and dvi input and there are no diffrence between them.Leave a comment:
No activity results to display
Leave a comment: