Re: Asus Rog Strix B360-I Gaming - Parts Identification
Hello DynaxSC! Glad to hear that the board is working again!
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: Asus Rog Strix B360-I Gaming - Parts Identification
It seems to me that you're only missing another resistor. [URL="https://ru.gecid.com/data/mboard/201907300800-56873/img/09_asus_rog_strix_b360-i_gaming.jpg"]See this pic[/URL] ([URL="https://ru.gecid.com/mboard/asus_rog_strix_b360-i_gaming/"]source[/URL]). The resolution of the picture only hints that the missing resistor has 2 digits written on top, so it might not have the same value as the one you still have on that area.Re: Asus Rog Strix B360-I Gaming - Parts Identification
It seems to
Leave a comment:
-
Re: Asus X99-s USB overcurrent detected
00 usually means a big issue with your cpu. What BIOS version are you running?
Have you tried reseating your CPU?...
Leave a comment:
-
[MSI KT3 Ultra ARU] Advice on capacitor choice
I've found out that the all the Nichicon HM(M) caps on this board are faulty and need replacement. However, I didn't plan in advance and I don't have good replacement caps.
The original values are 2200uF, 6.3V, 5mm pitch. According to the [URL="http://www.nichicon.co.jp/english/products/pdf/e-hm.pdf"]datasheet[/URL], the rated impedance should be around 13-18 uOhms.
There are 8 of them, 3 to the left of the CPU socket and 5 on the bottom, very close to the northbridge. They are all connected, according to my multimeter.
[ATTACH]308947[/ATTACH]...
-
Abit NF7-S 2.0 short while recapping the AGP cap?
Hello!
I have an old Abit NF7 that was stored after working OK and when I took it out of storage it didn't boot at all. I saw that the nichicon capacitor right under the AGP port was visibly damaged and today I proceeded to replace it with an equivalent Panasonic FR (EEUFR0J182).
Prior to that, I measured the ESR value of both the new one (0.024 ohms) and the bad one (>1 ohm) using an aliexpress meter (MESR-100 v2). As everything seemed ok, I went ahead.
Besides a very poor solder job on my part I went to check resistance and continuity (just for...
No activity results to display
Show More
Leave a comment: