If I fail I wont be feeling bad about buying the master or having someone solder those pesky pins. Besides I have done plentyof smd's no problem... hopefully this will be a similar task.
After careful inspection found one of the pins fried on the Master inverter. I believe it is MU1. It has 16 pins on both sides. Now, where to get the part... anyone?
... that and some loctite super glue lol. Im not satisfied with this. I am not satisfied with this at all! Any suggestions on a proper fitment method?
If not I will return it and try what Kingofcoins has done and go from there.------ I did see that the board has an alternate...
So here is what is going on that I need a little help with... I opened her up and found my main board number to be 3642-0502-0150. I looked for a mainboard that matched but nobody had one in stock. So I decided to order the 3642-0472-0150. My logic was that since they are the same model Television, then they should take the same mainboards. So my question is.. would this swap...
Leave a comment: