Re: Kenwood Chef A901e

All Fixed.
Thanks

Hi

I'm trying to restore a Kenwood Chef A901e, the one with the PCB motor controller but I'm struggling a bit with the correct wiring layout. I've replaced all the caps and triac plus the 56 Ohm resistor.

If we look at the pcb from the top with the heatsink/triac to the right:

Terminal 1: below 150nf cap
Terminal 2: above and to left of 150nf cap
Terminal 3: above and to right of 100nf cap
Terminal 4: heatsink

| have wired it up as follows:

Terminal 1: blue from connector block and yellow from motor
Terminal...