Re: Gigabit Gtx 980ti garbage display

Are all other drivers up to date? Have you tried a clean driver install? I've never had to use ddu but with Nvidia choosing custom installation and picking clean install has solved alot of display problems with me in the past.

Re: Dell T5810 bios mods, motherboard mods, schematic help

Well if anyone cares I'm going to but some 2.2 resistors and solder them on. Don't have much to go on other than a guess lol. I contacted infenion who makes the vrm controller and MOSFETs for my board and they told me they can't assume what the current sense is on my board and from an inside source the Dell schematic is nda. I've given up trying to meter out guess work so I'm just going with my gut. If I get the board it's 45 bucks. I'm going to stick a cpu on it that I don't want to use Incase I cook that too along with...

Re: Dell T5810 bios mods, motherboard mods, schematic help

Could someone please explain a little about the vsen and vrtn pins 5 and 6 on this schematic?...

Re: Rx 580 8gb powercolor red dragon not working

I can't answer what the missing component is. However looking at that photo it looks like someone was playing with the shunt resistors doing a power mod. I can't tell if those resistors we're replaced or it was a failed attempt to stack them regardless I think someone melted some other components off with a hot air gun. Anyways even if you find your missing part I'd make sure those 2 shunt resistors are correct.

Re: Dell T5810 bios mods, motherboard mods, schematic help

Have to quit for the night but I found another pwm controller.on the board a ncp6133. Here is a quote from the data sheet. I think the resistor I pictured above which there are 6 of are feeding it. Here's the quote.
[CODE]
Total Current Sense Amplifier
The NCP6133 uses a patented approach to sum the phase
currents into a single temperature compensated total current
signal. This signal is then used to generate the output voltage
droop, total current limit, and the output current monitoring...

Re: Dell T5810 bios mods, motherboard mods, schematic help

Could someone help me identify exactly what resistor this is. I can measure with a caliper if needed. I believe the markings indicate 2.2 ohms. My meter reads 2.4 but also varies .1 to .2 when touching the leads together....

Hi. I sorta posted this in another section but I'd like to ask this a little differently. I'm trying to figure something out on my motherboard for modification. It may not be possible to find a schematic for this Dell but I'd take any hardware using a c612 chipset to study. I know that it will be different but any schematic from that chipset should show me how cpu current is monitored and I can reverse that onto my board. Any help or general direction would be appreciated.

Hello all. Hoping this is the right section to post and I have 3 questions that any one of them answered should fix me up. So I have a Dell precision T5810 with an E5-1650v3 cpu. I've been overclocking it using throttle stop. I'm at my TDP limit of 140 watts and I can't get past it. Where I'm at right now is in order from best solution to worst.
1 I need an unlocked bios. I have all the ami bios tools and a spi programmer. I've tried modding it and a couple of people from bios mods and win raid tried modding. I can't get any other menus to show up. If someone can successfully mod my bios...

Re: New Members - please post your introductions here

Hello all. Was referred over here after getting a little to technical on another forum lol. Skimming through I think I can give and receive alot of help over here.