Hi all,

I'm working on reviving a Game Gear Power Supply that has some issues with the voltage output for one of the pins. The power supply should provide the correct voltages for each pin (please see attached photo) and I could not get 34V for the last pin. In fact, I got like 0.4 to 0 volts when measured with a multimeter when it powers on.

What I did so far was to change the 3 electrolytic capacitors and have also tested using an ESR meter and all 3 capacitors are fine. Next I checkED for any shorts and I discovered that both solder joints (+) and (-) for one capacitor...

Re: New Members - please post your introductions here

Hey Yo,
I was advised by someone on Youtube to check in this forum.
New to electronics so I'm learning new things every day.