Re: Need schematics/boardview of Palit GTX 1060 3gb

Hello, again!
So, my units 1 and 3 are empty. The buck convertor in question (the one I think does the 5 v) is U3.
The BC itself is 08-50E and I was unable to identify it more specifically.
I tested 2 of the 0 Ohms resistors near (marked on one of the pics) - they both shows values between 0.002-3. On the other hand, some times they read O.L. I read a little bit and even on 0 ohms resistors 0 or 0.001 is different from O.L. Not sure if my multimeter (Mestek DM90A) has some problems though.
On the buck...

Re: Need schematics/boardview of Palit GTX 1060 3gb

Hello and thx for your reply!
Yes, I know that about the voltages. But I have 0 v. to the buck convertor that should start the 5 v rail. I have 0 v. on all 8 legs, which should means that nor the 3.3, nor the 12 v (VIN), are getting there. I'd like to know why is that. I need to find the 3.3 way to the convertor and the 12 v to the VIN pin, right?
I have few boardviews from 1070, but if you have something closer to mine, I will very appreciate if you share it with me.
Also any advice on what should my steps...

Hello, I have faulty 1060. I'm missing 5 and 1.8 v. 12 and 3.3 seem fine. I need schematics or board of of this card or of a similar one so I can trace the 12 v rail to the 5v buck converter.
Also If someone had dealings with such a card, I will appreciate the assistance.
Thanks in advance!

Re: Graphics card Schematics and Boardviews

Hello, guys! First time here. I'm learning to repair Gigabyte 1070 8gb Founders edition (Ser. # GV-N1070D5-8GD B rev.1). Do someone of you have any schemes/board views of that card or something close to it as PCB? Thank you in advance!