Re: X555LD HDD Board change
Ok tanks for all the suport Guys! It works and I am an idiot. I just had to put the screws in.
I will close the Thread!
Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Re: X555LD HDD Board change
Ok, i have these leds here on the small board and they are not working. So I guess it could be because I havent enough voltage. If someone know how to higher voltage at that point, I wold be thankfull. The LEDS are on the "USB Bord" that I mentioned before. This board is connected through the HDD Board. As you can see on the picture of the whole Comuter....
Leave a comment:
-
Re: X555LD HDD Board change
I get an error if I want to Upload the image. Its sayd that file is invalid. If you know why, feel welcome to let me know.
So this is what it says at the Save and Exit site of my bios:
Save Changes and Exit
Discard Changes and Exit
Save Options:
Save Changes
Discard Changes
Boot Override:
launch EFI Shell from filesystem device
Leave a comment:
-
Re: X555LD HDD Board change
I can hear the HDD for about half a second and than it stops. So maybe you are right about your suggestion. Is there a way to higher the voltage?
Leave a comment:
-
Re: X555LD HDD Board change
That was my Problem With the Old HDD Board. After I changed it, it didnt work. So I checked the Voltage at that Point with a Multimeter (I learned later that this could be a bad Idea)
But there is voltage at the connector....
Leave a comment:
-
Re: X555LD HDD Board change
Thank you, this was already helpful. I already tested another hdd on the Computer. This is Not detected too.
The HDD Board is connected to a „usb Board“ (Not sure of this is the Name) the usb Port on this „usb Board“ is Not Working as well. So as the too Parts (the HDD an the Usb) are connected to the HDD Board and they are Both Not working and I already Tried anothe HDD I am quite Sure, That the HDD Board is the Problem. This one is new,so I am quite sure That it should be working.
I tried to enter legacy,...
Leave a comment:
-
Re: X555LD HDD Board change
I already Entered the bios. I just cant enter easy flash Mode because the battery is Broken. Therefore I cant charge it till 20%. So my question is if I can flash bios without entering the easy flash mode. For example with Linux....
Leave a comment:
-
Re: X555LD HDD Board change
Is there a way to flash bios without entering the easy flash mode? I cant enter the easy flash mode with a broken battery. Can I flash bios on linux?
Leave a comment:
-
X555LD HDD Board change
Hi everybody,
i am quite new at reparing electronics, so please be patient with me
I have an Asus F555LF notebook. The first problem was, that i didt find my hard disk on bios. I found out that the X555LD Rev 3.6 HDD Board was broken. So and I changed my X555LD HDD Board. Now I have the problem that I cant find the hard disk too. I tried to reset bios by removing the bios battery. It became clear, that the batterie of the notebook is the CMOS Batterie as well. My first question is. Is this right or can I just not find the CMOS Batterie?
Its also quite...Last edited by Azhar691; 09-27-2021, 11:45 AM.
-
Re: New Members - please post your introductions here
Hello everybody, i am Azhar.
I am a 21 years old mechanical engineering student from Germany and I joined this forum because of a problem with my notebook
However, i hope i can learn a lot from you guys. Please let me know,if you have further questions about me.
Thank you very much for your posts here. I am already learning from you guys
Leave a comment:
No activity results to display
Show More
Leave a comment: