Announcement

Collapse
No announcement yet.

User Profile

Collapse

Profile Sidebar

Collapse
Avatar
bobbyg0001
Bob
Last Activity: 02-22-2013, 03:50 PM
Joined: 06-05-2011
Location: Sacramento, CA
  •  
  • Filter
  • Time
  • Show
  • Source
Clear All
new posts

  • Re: HP Pavilion dm3 would not powering on

    This model has an Intel chip. You should try another power button switch.
    See more | Go to post

    Leave a comment:


  • Re: HP DV6 1120ef won't start - power LED on

    Did you ever figure this one out. I've got an HP G71 G71-442. No boot - no power. Intel cpu chipset graphics. Same N channel with no reading. Tried to locate on the net (digikey et.), but found nothing. Thanks
    See more | Go to post

    Leave a comment:


  • Re: HP G71-449MW blank screen issue

    OK. I loaded the recovery os on a hard drive in the working, waiting for a new screen G71. Swapped the drive over into the dim, barely readable G71. Hooked up an external monitor and I got a screen on external. But, I had to set it up while in the Windows os. Seems the newer HP's do not load the vga connector i.e. DV 2000-6000-9000 etc. by default. Correct me if I'm wrong. With the dim screen I loaded the monitor via the function keys on the keyboard. Once in the control panel I could switch in and out of the external monitor. But I still do...
    See more | Go to post

    Leave a comment:


  • Re: HP G71-449MW blank screen issue

    Well, this mourning I decided I should hook up the lcd from the other G71. I'm waiting for a new screen for this one as it has horizontal lines on the screen. (No, its not the video cable) I hooked it up and lo and behold the laptop is posting and I can enter the BIOS screen, although its extremely long to boot. About 30 seconds. But, it is almost to dim to see. And the funny thing is I'm setting up the good G71 with the original os, using the LCD screen with the lines in it, and this G71 would not show on the external monitor either. Not funny!...
    See more | Go to post

    Leave a comment:


  • HP G71-449MW blank screen issue

    I picked this hp g71-449wm recently with a known damaged lcd screen. But, I cannot get a video signal on an external monitor. Nor can I get video from the lcd connector on the mainboard. I tested the screen with another g71 and it is defintely damaged and will light up. I've tried the hard reset, different RAM modules. New CMOS battery. Remove and reinstall CPU. Tried another processor. And its more than likely overheated before, as the fan needed a good cleaning, but I can't say for sure.
    This HP has an Intel T4300 processor and the Intel 4500M vga. Visuals reveal nothing out of the ordinary,...
    See more | Go to post
No activity results to display
Show More
Working...
X